Productafbeelding Wheeled frame for Angio Ergometer w. fixation set

Wheeled frame for Angio Ergometer w. fixation set

Part number: 967800
To Specifications

Easy installation of the Angio ergometer

Wheeled frame for the Angio ergometer with fixation set (separately sold) that makes it very easy to place the ergometer over a patient bed and move it. The wheeled frame  is executed with a part of instrument rail (10 * 25 mm) to conveniently connect an additional wired control unit (separately sold) during transport.

Note: the wheeled frame is not compatible with former models of our Angio ergometer (9179XX). For a wheeled frame for these ergometers, contact our sales department and ask for part number 917816)

  • Specifications
  • Support
  • Dimensions

Dimensions

product length (cm) 76 cm (29.92 inch) length of product in cm
product width (cm) 120 cm (47.24 inch) width of the product in cm
product height 100 cm (39.37 inch) height of product
product weight 15 kg (6.8 lbs) the weight of the product

Certificates

CE Certificate Stress Test and Force Measurement Devices

ISO 9001:2015 Certificate

UL CSA Angio series certificate

Manufacturers Declaration of Conformity 27 Lode

IEC 60601-1:2005 – ed. 3 + C1 + C2 (cycle ergometers) certificate

FDA Registration certificate

Dimension pictures

967800 Dimensions wheeled frame Angio

Frequently asked questions

Can the contrast of a single display bicycle ergometer be changed?

Yes, on the backside of the display there is a potentiometer. To have access to this potentiometer you have to remove the upper part of the control unit by removing the screws on the bottom side of the controlunit. ( see service manual for instructions) now you can access the potentiometer and adjust it according you wishes.

Can I use a RS232 to USB converter to connect an ergometer?

Yes you can. Make sure the chipset used in the converter is from FTDI to have good data acquisition.
Not sure what this means? Contact us and we will help you to get the right converter.

Is Lode recommending special disinfection procedures for the Lode products due to COVID-19?

Yes, Due to the fact that the scientific research on the spread of Covid-19 is not yet conclusive Lode recommends to disinfect and clean all Lode products and their accessories (cuffs, heart rate belts, SpO2 sensors, handgrips/rails, touchscreens etc) that are in contact with the patient and or the medical personnel with a standard disinfectant as used in the hospital before and after every patient, with attention and care!

Since these agents are sometimes aggressive it might be advisable to check the effect on sensitive surfaces, like cushioning on non-visible areas. Lode will not take responsibility for discoloration due to these agents.