SpO₂ for Control Unit with Touch Panel (Extra Long Cable)
SpO₂ for Control Unit with Touch Panel (Extra Long Cable) enables real-time monitoring of peripheral oxygen saturation directly on the touchscreen display of your Lode control unit. This option enhances the safety and diagnostic capabilities of exercise testing and rehabilitation by providing continuous SpO₂ data during physical exertion.
The extended cable length allows for greater flexibility in positioning the sensor and control unit, making it ideal for use in clinical environments where mobility or setup variability is required.
Important:
This option is only available when ordered together with a (Programmable) control unit with touchscreen (article numbers 945814/5 or 945834/5). It is not compatible with other configurations.
Accessories
- Support
Manuals
M945822 - manual SpO2 for control unit with touch panel English
Date of publication: December 5, 2023
M945822 - manual SpO2 for control unit with touch panel Dutch
Date of publication: December 5, 2023
M945822 - manual SpO2 for control unit with touch panel German
Date of publication: December 5, 2023
M945822 - manual SpO2 for control unit with touch panel Greek
Date of publication: December 5, 2023
M945822 - manual SpO2 for control unit with touch panel Spanish
Date of publication: December 5, 2023
M945822 - manual SpO2 for control unit with touch panel Italian
Date of publication: December 5, 2023
M945822 - manual SpO2 for control unit with touch panel Polish
Date of publication: December 5, 2023
M945822 - manual SpO2 for control unit with touch panel Portuguese
Date of publication: December 5, 2023
M945822 - manual SpO2 for control unit with touch panel Turkish
Date of publication: December 5, 2023
Frequently asked questions
Is Lode recommending special disinfection procedures for the Lode products due to COVID-19?
Yes, Due to the fact that the scientific research on the spread of Covid-19 is not yet conclusive Lode recommends to disinfect and clean all Lode products and their accessories (cuffs, heart rate belts, SpO2 sensors, handgrips/rails, touchscreens etc) that are in contact with the patient and or the medical personnel with a standard disinfectant as used in the hospital before and after every patient, with attention and care!
Since these agents are sometimes aggressive it might be advisable to check the effect on sensitive surfaces, like cushioning on non-visible areas. Lode will not take responsibility for discoloration due to these agents.
Is it possible to lower the workload in case of a sudden SpO2 drop?
SpO2 can be used to control the load of the ergometer. In the tab “SpO2 ” you can choose to use SpO2 for automatic load adjustment and you can edit the settings (see manual LCRM 950902)