Check environmental conditions during test
The sensor pack allows for checking the following conditions:
- ambient temperature (C)
- air humidity (%)
- airpressure (mBar)
When a control unit is available the data can be made visible continuously.
Data will be able for viewing and storing in Lode software like LEM (from 10.4.1).
- Specifications
- Support
Accuracy
| Minimum measured air pressure | 550 hPa / mBar | Minimum measered air pressure |
|---|---|---|
| Maximum measured airpressure | 1150 hPa / mBar | Maximum measured airpressure |
| Measured air pressure accuracy 50 - 115 kPa (+/-) | 5 kPa | Measured air pressure accuracy 50 - 115 kPa |
| Minimum measured temperature | 5 °C | Minimum measured temperature |
| Maximum measured temperature | 50 °C | Maximum measured temperature |
| Temperature measurement accuracy -25 - 85 °C (+/-) | 2 °C | Temperature measurement accuracy (+/-) -25 - 85 °C |
| Minimum measured humidity | 10 % RH | Minimum measured humidity |
| Maximum measured humidity | 90 % RH | Maximum measured humidity |
| Measured humidity accuracy 10 - 90% RH (+/-) | 10 % RH | Measured humidity accuracy 10 - 90% RH (+/-) |
Frequently asked questions
Is Lode recommending special disinfection procedures for the Lode products due to COVID-19?
Yes, Due to the fact that the scientific research on the spread of Covid-19 is not yet conclusive Lode recommends to disinfect and clean all Lode products and their accessories (cuffs, heart rate belts, SpO2 sensors, handgrips/rails, touchscreens etc) that are in contact with the patient and or the medical personnel with a standard disinfectant as used in the hospital before and after every patient, with attention and care!
Since these agents are sometimes aggressive it might be advisable to check the effect on sensitive surfaces, like cushioning on non-visible areas. Lode will not take responsibility for discoloration due to these agents.